that will be served.If using a Cable/DSL Modem, reboot or power cycle the modem off and on before using this link for the first time.The instructions below offer the configuration for both AC and M devices:the settings are very similar with just small modifications that will be pointed out for the different platforms.Visit our worldwide community of Ubiquiti experts for more answers

Use Ubiquiti ToughCable Pro shielded twisted pair data cable between your Power over Ethernet adapter and your radio. Buy Ubiquiti Rocket M5 in kenya User Tips. Ubiquiti’s airMAX ® technology is proven in millions of deployments worldwide, exhibiting outstanding performance in outdoor environments. Find the steps on how to make this configuration for both AC and M devices below. Clearly, a more complex approach is often desired, one that uses multiple Ubiquiti radios with sector antennas along with a fully routed (rather than bridged) configuration.

This article describes the configuration needed to create a Point-to-Multipoint (PtMP) link.PtMP links are used routinely to serve up to 100 locations from a single Access Point. computers, printers, etc.) Before following these steps, install a router as shown in the diagram above. The Point to Multipoint wireless 320 delivers high throughput for optimized performance, serving up to 200 subscribers per sector with a typical aggregate bandwidth of up to 45 Mbps (10 MHz channel) and even higher throughput with Multiple Input/Multiple Output (MIMO) technology. I've got a unique situation where I need POE cameras along a linear path. airOS firmware technology enables high-performance, outdoor multi-point networking. Ubiquiti’s versatile airOS ® firmware technology enables high-performance, outdoor multi-point networking. Bridges. The TDMA airMAX protocol enables unprecedented scalability, high throughput and low latency in unlicensed, multipoint networks. Ubiquiti UniFi UAP-AC-PRO-US 802.11AC, 3x3 MIMO technology, 1300 Mbps 5 GHz POE+ Outdoor Managed Wireless Access Point Interface: (2) 10/100/1000 Ethernet Ports Standards: 802.11 a/b/g/n/ac Reboot or power cycle the modem off and on before using this link for the first time.3. Point to Point Bridges.

Product information Package Dimensions 11.3 x 8.4 x 3.6 inches Item Weight 2.01 pounds Select the correct cable. That however, is not the scope of this article. Prime members enjoy FREE Delivery and exclusive access to music, movies, TV shows, original audio series, and Kindle books.

KuWFi 2-Pack 300Mbps Wireless Outdoor CPE Kit Point-to-Point Wireless Access Point 2.4G WiFi Bridge Supports 1KM Transmission Distance Solution for PTP/PTMP (Pre-Program) 3.9 … See our TOUGHCable Datasheet for more information. Channel width flexibility (10/20/30/40/50 MHz) allows independent TX and RX channel frequency configurations anywhere within the radio band to avoid local interference. After viewing product detail pages, look here to find an easy way to navigate back to pages you are interested in.After viewing product detail pages, look here to find an easy way to navigate back to pages you are interested in. If the Access Point will be co-located with high-power VHF transmitters, also use Ubiquiti ToughCable Carrier cable. If you want to configue it as a wireless bridge, then you require one end to be "Root Bridge" and other end to "Non Root Bridge" In WGB mode, since that AP act as a wireless client, you simply require Autonomous AP (in Root Access point mode, not root bridge) or Light Weigth AP to associate with. Incorporating Ubiquiti's proprietary LTU technology, the LTU-Rocket is a Point-to-MultiPoint (PtMP) 5 GHz Access Point featuring 2+ Mpps processing, proprietary RF filtering, and flexible GPS sync for superior performance.